Agilent Technologies 8753ES Manuel d'utilisateur

Agilent 8753ET/8753ES Network Analyzers8753ET, 300 kHz to 3 or 6 GHz8753ES, 30 kHz to 3 or 6 GHzConfiguration GuideSystem configuration summaryThe fol

10Test configuration accessoriesRF limiterExternally attaches to one or both test ports of the analyzer. Provides protection against potentialhigh-pow

11PeripheralsThe following peripherals may be used with theAgilent 8753ET and 8753ES. Other peripherals not listed here may also be compatible with th

12Network analyzer upgrade kitsUpgrade kits for the Agilent 8753ET or 8753ESUpgrade kits are available to add options to an analyzer after initial pur

13• 8753EU Option 099 firmware upgrade kitThis upgrade provides the latest firmware revisionfor the 8753E, which includes the new firmwarefeatures int

14Further informationPub. number8753ET and 8753ES overview 5968-5159E8753ET and 8753ES data sheet 5968-5160E For more information about the Agilent 87

15Related literatureApplication and product notesMost application and product notes may be downloaded from our Web site at www.agilent.com/find/tmappn

Windows®is a registered trademark of Microsoft Corporation.Agilent Technologies’ Test andMeasurement Support, Services, andAssistanceAgilent Technolog

2Agilent 8753ET network analyzerA standard 8753ET covers 300 kHz to 3 GHz,includes a built-in transmission/reflection test set, and has two 50 ohm typ

3• Option 014 configurable test setAdds SMA connectors on front panel for accessto various source output and receiver input sig-nal paths, including d

4General product optionsThe following options are available for both theAgilent 8753ET and 8753ES.Rack mount options• Option 1CMrack mount kit without

5Measurement accessoriesAccessories are available in these connector types: 3.5 mm, 7 mm, 50-ohm type-N, 7-16, 75-ohmtype-N, and type-F. A standard 87

6• 85038F 7-16 calibration kit (female standards)Contains fixed load, open, and short circuit with7-16 female connectors and a 7-16 (f) to 7-16 (f)ada

7Verification kit• 85029B 7-mm verification kit Includes attenuators and mismatch attenuatorwith data on a 3.5-inch disk for use in confirm-ing system

875-ohm device measurementsTest-port cables• 11857B 75-ohm type-N test-port cablesA pair of phase-matched 610 mm (24 in) cables,for use with the 8753E

9Test sets (for use with 8753ES Option 011)• 85046B 75-ohm S-parameter test set300 kHz to 2 GHz. Requires the 11857B 75-ohmtest-port return cables. In