Agilent Technologies 86100D Manuel d'utilisateur télécharger pdf (Page 19)

Precision Timebase

86100D

The 86100D DCA-X wide-bandwidth oscilloscope uses a

built-in timebase to acquire and display waveforms. While

the standard timebase is sufficient for most applications,

some high-speed measurements benefit from using the

precision timebase capabilities of these modules. The preci-

sion timebase significantly reduces the scope’s random jitter

contribution and minimizes clock-data delay.

86107A

Precision timebase reference

Low oscilloscope jitter allows the true jitter performance

of devices to be seen. The 86107A is used in tandem with

any of the optical or electrical sampling modules to reduce

mainframe trigger jitter below 100 fs. It is optionally

configured to accept 10 G, 20 G, or 40 G input clock signals.

(Oscilloscope jitter can be driven to even lower levels when

using the 86108A precision waveform analyzer).

For more information:

www.agilent.com/find/86107A

86108A

32 GHz dual channel electrical with integrated precision

timebase and clock recovery

At less than 60 fs (typical), the 86108A provides the indus-

try’s lowest scope jitter. This means that the signal you see

on the scope’s display is not degraded by the scope itself.

The 86108A can derive a clock from the test signal and

internally feed the precision timebase section. Or an external

timing reference can be provided to the precision timebase.

Ultra-low jitter is achieved in either configuration.

For more information:

www.agilent.com/find/86108A

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Agilent Technologies 86100D Manuel d'utilisateur Page 19