Agilent Technologies E8403A Guide d'installation télécharger pdf (Page 48)

Setting Up ParBERT Modifying an Existing ParBERT System

48 Agilent 81250 ParBERT Installation Guide, February 2002

To open a module:

1 Using a T-10 size Torx screwdriver, remove the seven screws from the

side panel of the module. The locations of the screws are shown in

Figure 25.

Figure 25 Cover Screws of ParBERT Modules

2 Set the cover and screws to the side.

How to Add or Exchange a Frontend

This section describes the work necessary to exchange frontends of the

delivered ParBERT modules.

NOTE After adding or exchanging frontends, make sure you finish up according

to the description under ”How to Proceed After Changing the

Hardware” on page 56.

There are two types of frontends for ParBERT: generator frontends and

analyzer frontends. These are shown in the following illustrations.

Figure 26 Generator Frontend of an E4861A Module

3 shorter

screws

4 longer

screws

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 103 104

Pas de commentaire

Agilent Technologies E8403A Guide d'installation Page 48