Agilent Technologies 85032B/E 50 Spécifications télécharger pdf (Page 4)

System performance

Two-port calibration (user)

Specification

(dB) Typical

(dB)

Parameter 3 MHz 1.3 GHz 2.2 GHz

to 1.3 GHz to 2.2 GHz to 3 GHz

Directivity 40 38 35

Source match 38 35 30

Load match 40 38 35

Reflection tracking ±0.1 ±0.1 ±0.2

Transmission tracking ±0.1 ±0.1 ±0.2

Transmission uncertainty (typical)

Magnitude

Phase

1. These specifications and supplementals apply under the following conditions: measurement uses the “Fine” (15 Hz) bandwidth, no averaging, and isolation cal “on”; Test Set

Cals use the “Fine” (15 Hz) bandwidth, 16 averages, and assume an isolation calibration has been performed; the test set must be used with an 8712ES or 8714ES network

analyzer with firmware revision E.06.00 or later; the test set and the analyzer must have had their performance verified within the last year; both instruments must have

warmed up for at least 30 minutes after turn-on; measurements are made at an environmental temperature of 25 °C ± 5 °C and within ± 1 °C of the last valid Test Set Cal.

2. Corrected system performance is changed to typical when the current temperature has drifted beyond ± 1 °C of the last valid Test Set Cal. Typicals are valid only when the cur-

rent temperature is within 25 °C ± 5 °C, and within ± 1 °C of the most recent SelfCal.

3. These uncertainty curves only include the effects of the test port(s) within the measurement path. The effect of the uncorrected match of test ports outside the measurement

path is ignored, and is dependent on the isolation between the ports of the DUT that are within the measurement path and ports of the DUT that are outside the measurement

path.

Agilent 85033D 3.5mm calibration kit

1 2 3 4 5 6 7 8 9 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies 85032B/E 50 Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies 85032B/E 50