Agilent Technologies E6630A Manuel de service télécharger pdf (Page 17)

18 Getting Started Guide

1 Quick-Start

8 Verify the installation a From the mouse right-click

menu, select

Utility, Virtual

Front Panel

. (All

key-presses that follow

refer to the keys shown on

the Virtual Front Panel.)

b Press

System, Show,

System.

c Verify that the purchased

application(s) appear in the

list.

• If you require further assistance, contact the Agilent

support team.

Online assistance: http://www.agilent.com/find/assist

9 Attach a loopback cable a Use an RF cable to connect

the front panel RF In and

RF Out ports for this

sub-instrument.

• The purpose is to use a loopback cable to verify that

the test set’s source can generate a signal and the test

set’s analyzer can measure it.

10 Generate and view a

signal

a Press

Input/Output, More,

RF Output & Test Set

Config

, RF Output,

RF Output

b Press

AMPTD Y Scale, Ref

Value

, 10, dBm.

c Press

FREQ, Center Freq,

2.4, GHz.

d Press

SPAN X Scale,

Span, 8, MHz.

e Press

Source, Frequency,

2.4, GHz.

f Press

Source, RF Output,

On.

g Press

Source, Amplitude,

RF Power, 0, dBm.

• Select RF Output rather than GPS Output.

• Set the amplitude reference to 10 dBm

• Set the analyzer center frequency to 2.4 GHz.

• Set the analyzer span to 8 MHz.

• Set the source frequency to 2.4 GHz.

• Set the source RF output to On.

• Set the source amplitude to 0 dBm.

• To ensure accurate power levels from the source, see

“Source Level Accuracy" on page 20.

Steps Actions Notes

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 106 107

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies E6630A Manuel de service Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies E6630A