Agilent Technologies Ininiium 9000 Guide de l'utilisateur télécharger pdf (Page 82)

Using the Oscilloscope

To set the horizontal reference point

3-46

To set the horizontal reference point

• Click on one of the arrows at the bottom of the waveform display.

The selected horizontal reference is highlighted.

The vertical arrows at the bottom of the display correspond to the left, center, and

right horizontal reference points. This is the position of the trigger if the horizontal

position is set to zero delay. A non-zero horizontal position value is the time relative

to the trigger event at the selected horizontal reference point.

Figure 3-19

Horizontal Reference Points

Click to set the

horizontal

reference to the left

side of the display

Click to set the

horizontal

reference to the

center of the display

Click to set the

horizontal

reference to the

right side of the

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 111 112

Pas de commentaire

Agilent Technologies Ininiium 9000 Guide de l'utilisateur Page 82