Agilent Technologies 8485D Manuel de service télécharger pdf (Page 59)

Service

Chapter 3 49

Disassembly / Reassembly Procedures

Disassembly Procedure

Disassemble the Power Sensor by performing the following steps:

CAUTION Disassembly must be performed in sequence described in the following procedure,

otherwise damage may be caused to the two gold wires between the bulkhead

assembly and the Power Sensor Board Assembly. If these wires are damaged, the

A1 Bulkhead Assembly must be replaced.

NOTE Every Power Sensor has an individually prepared label on the housing. If more than

one power sensor is disassembled at a time, be sure to mate the correct Power

Sensor and housing when reassembling.

Step 1. Insert the blade of a large screwdriver between the two-piece plastic shell at the rear

of the Power Sensor. Gently pry the sections apart. (See Figure 3-4.)

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 85 86

Pas de commentaire

Agilent Technologies 8485D Manuel de service Page 59