Agilent Technologies U1401A Guide d'installation télécharger pdf (Page 10)

6 Data Logger for Agilent Handheld Multi-function Calibrator and Meter Installation

3 Equipment Setup and Connection

Connect the U1401A/U1401B Handheld Multi- Function

Calibrator/Meter to a computer for instrument control:

1 Set up the communication parameters of the U1401A or

U1401B, and the personal computer you are using. The

default values for baud rate, parity, data bit, and stop bit

in the U1401A are 9600, n, 8, and 1 respectively.

2 Ensure that the USB driver and the IR transfer software

has been installed on your computer.

3 Attach the optic side of the cable to the communication

port on the meter. Ensure that the Agilent logo side is

facing upwards.

4 Plug the USB cable terminal end into the USB port of

your personal computer.

5 Use the Data Logger to retrieve the data that you need.

To U1401A or U1401B IR

communication port

To PC U S B p o r t

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Agilent Technologies U1401A Guide d'installation Page 10