Agilent Technologies E1326B Manuel d'utilisateur télécharger pdf (Page 60)

DISPlay

The DISPlay subsystem monitors the channel state of a selected module (or

card). This command can only be used when the FET multiplexer module

is used in a switchbox configuration. It operates with mainframes that have

a display, such as the Agilent 75000 Series B Mainframe (Agilent Model

Number E1301). It also operates with terminals connected to the serial

interface port.

Subsystem Syntax DISPlay

:MONitor

:CARD <

number | AUTO>

[:STATe] <

mode>

:MONitor:CARD DISPlay:MONitor:CARD <number | AUTO> selects the module in a

switchbox to be monitored.

Parameters

Parameter Name Parameter Type Range of Values

number | AUTO

Numeric 1 - 99

Comments

• Selecting a Specific Module to be Monitored: Send the card

number in a switchbox with the

DISPlay:MONitor:CARD command.

• Selecting the Present Module to be Monitored: Use the

DISPlay:MONitor:CARD AUTO command to select the last module

addressed by a switching command (e.g.,

[ROUTe:]CLOSe).

• *RST Condition: DISPlay:MONitor:CARD AUTO

Example Select Module #2 in a Switchbox for Monitoring

DISP:MON:CARD 2 Selects module #2 in a switchbox.

58 Agilent E1351A/53A 16-Channel FET Multiplexer Command Reference Chapter 5

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 109 110

Pas de commentaire

Agilent Technologies E1326B Manuel d'utilisateur Page 60