Agilent Technologies U1251B Guide de l'utilisateur télécharger pdf (Page 2)

U1251B and U1252B Quick Start Guide

Charging the Battery

NOTE

For the battery charger, the mains supply voltage should not

fluctuate by plus or minus 10%.

CAUTIONCAUTION

• Do not rotate the rotary switch from position when

charging the battery.

• Perform battery charging only with 7.2 V or 8.4 V NiMH

rechargeable battery, 9 V size.

• Disconnect test leads from all the terminals when charging

the battery.

• Ensure proper insertion of battery in the multimeter, and follow

the correct polarity.

Use the specified accessory, the 24 V DC

adaptor to charge the battery.

1 Remove and disconnect the test leads from

the meter.

2 Turn the rotary switch to the

position. Connect the power cord to the DC

adapter.

3 Plug the Red (+)/ Black (–) banana

terminals of the DC adapter to the

and the COM terminals respectively. The

DC adaptor can be replaced with a DC

power supply in order to set the 24 V DC

output and the over current limitation to a

value more than 0.5 A. Ensure that the

polarity of the connection is correct.

4 The primary display indicates “bAt” and

the ‘SbY” flashes on the secondary display

and a short tone sounds to remind you

whether to charge the battery or not. Press

to start charging the battery, or the

meter will automatically start the self-test

after the 24 V supply is applied. We

recommend not to charge the battery if its

capacity is over 90%.

1 2 3 4 5 6 7 ... 12 13

Pas de commentaire

Agilent Technologies U1251B Guide de l'utilisateur Page 2