Agilent Technologies 81134A Guide de l'utilisateur télécharger pdf (Page 47)

Setting Up a Burst Signal Setting Up Generic and Advanced Signals

Agilent 81133A/81134A Pulse Generator User’s Guide, September 2008 47

The instrument panel now looks as follows:

Channel Settings for the PRBS Signal To set the channel parameters:

1 Switch to the Channel page.

2 Set the signal mode to RZ.

3 In the Timing panel:

–Switch from Dcycle to Width and set the Width to 100 ps.

– Set the Delay to 50 ps.

4 In the Levels panel, set:

– The level format to Custom.

– Amplitude to 2.0 V.

– Offset to 0.0 V.

5 Enable the Channel 1 normal Output:

By pressing the respective softkey in the user interface:

– OR –

By pressing the normal Out softkey for channel 1 next to the

Output port.

Burst RepetitionInstrument

Mode

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

Pas de commentaire

Agilent Technologies 81134A Guide de l'utilisateur Page 47