Agilent Technologies 4294A Manuel d'instructions télécharger pdf (Page 42)

100

101

34 Chapter 2

Learning Operation Basics

Specifying Measurement Conditions

Step 2. Press the LOG key to select Log (logarithmic) sweep.

Set the Sweep Start Value to 100 Hz

Step 1. Press the [Start] key. The current setting of the sweep start value appears in the Parameter

Setting field in the upper-left area of the screen.

Step 2. Type “100” into the Parameter Setting field using these ENTRY block keys:

[1][0][0].

Step 3. Specify that the value does not take any unit by pressing the

[´1] key in the ENTRY block.

This puts your entry into effect.

Set the Sweep Stop Value to 100 MHz

Step 1. Press the [Stop] key. The current setting of the sweep stop value appears in the

Measurement Parameter field in the upper-left area of the screen.

Step 2. Type “100” into the Parameter Setting field using these ENTRY block keys:

[1][0][0].

Step 3. Suffix your entry with “M” (mega) by pressing the

[M/m] key in the ENTRY block. This

puts your entry into effect.

Set the Measurement Bandwidth to 2

Step 1. Press the [Bw/Avg] key to display the Measurement Bandwidth/Averaging menu.

Step 2. Press the

BANDWIDTH [ ] key to display the Measurement Bandwidth Setting menu.

Step 3. Set the measurement bandwidth to 2 by pressing the

2 key.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 468 469

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies 4294A Manuel d'instructions Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Multimètres Agilent Technologies 4294A