Agilent Technologies 83640A Manuel d'utilisateur télécharger pdf (Page 8)

Installation Note 83650-90007 7

15. Refer to Figure 5. Remove the four screws from the source module interface assembly.

16. Lift off the source module interface assembly.

Figure 5. Source Module Interface Cable

17. Refer to Figure 6. Remove the two screws on each BNC printed circuit assembly attached to the

back of the front panel.

18. Slide out the connectors.

NOTE If the washer on the front of the connector is not centered properly, loosen the nut to slide

the connector out.

Figure 6. Front Panel BNC Locations

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Agilent Technologies 83640A Manuel d'utilisateur Page 8