Agilent Technologies 1100 Series Manuel d'utilisateur télécharger pdf (Page 66)

Repair and Maintenance

Recovering from an Operating System Crash

4 The PC will reboot and stop at the Login Information screen. The

pre-configured user is ‘Administrator’ and requires the password provided

with your PC.

5 Then press OK.

6 The next screen shows ‘End User Licence Agreement’ information. Read the

information and select I Agree and the PC will complete the boot process.

Figure 35 Licence Agreement

Step 2: Installation of TCP/IP protocol

1 From the Start menu in the Task Bar, select Start -> Settings -> Control Panel.

2 Select Network, to open the Network Properties dialog box.

3 Select the Adapters tab to check if a network card is configured on your

system (Figure 36).

4 Select the Protocols tab and check if a TCP/IP protocol is already installed. If

no TCP/IP protocol is installed (Figure 37), select Add to add a network

protocol stack, select TCP/IP Protocol and press OK.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Pas de commentaire

Agilent Technologies 1100 Series Manuel d'utilisateur Page 66