Agilent Technologies E6474A Guide de l'utilisateur télécharger pdf (Page 91)

Use Your System 4

Agilent E6474A User’s Guide 91

Figure 45 Data device added

Configuring data device properties

To perform throughput and timing calculations, you should use

Agilent Data Server Software. For more information on this

software and how it works, refer to the Agilent Data Server

software installation guide (E7475-90012).

Before you can perform a test with the data server, you must

configure the properties of the data device added to the data

port. The properties dialog box for the data device allows you to

configure the test conditions and parameters. See “Configuring

devices and views" on page 84 for instructions on opening this

dialog box.

NOTE

Although the Agilent E6474A software shows the COM port in the System

Setup view that the data device is connected to, that COM port cannot be

used for configuring the device’s properties. Data Device properties can

only be configured by right-clicking on the Data Device, then choosing

Properties from the pop-up menu.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 183 184

Pas de commentaire

Agilent Technologies E6474A Guide de l'utilisateur Page 91