Agilent Technologies E5500 Series Spécifications télécharger pdf (Page 34)

34

6. Start New Measurement.

a) Select New Measurement from the Measure

pulldown menu.

b) At the connect diagram, check hardware and

connect the signal path to the signal input of

the phase noise test set.

c) Select Continue.

d) When prompted by the software, connect the

calibration signal from the calibration source

to the coupler, then select Continue.

e) When prompted by the software, disconnect

the calibration signal from the calibration

source, then select Continue.

7. When the measurement is complete, print the

results and save the measurement file.

Figure 4-3. AM noise of an Agilent 83732B under

pulsed carrier conditions

1 2 ... 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire