Agilent Technologies 71501D Manuel d'utilisateur télécharger pdf (Page 19)

1-13

Getting Started

Steps for Setting Up Eye-Diagram Analysis

2 If you are using 70841A/B pattern generator and 70311A signal generator

modules with your eye-diagram analyzer, connect cables to the instruments as

shown in the following graphic.

• If you are using a clock source other than an 70311A, make sure that the

signal generator and 70820A microwave transition analyzer module share

the same frequency reference. Use the 10 MHz REF connectors on the rear

panel of the 70820A.

Rear-Panel Cable Connections

3 Connect the front-panel cables as shown in the figure on the following page.

Use an adapter between the cables and channel connectors. The data signal

connects to the 70820A’s RF INPUT 1 connector. The trigger or clock signal

connects to the 70820A’s RF INPUT 2 connector.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 175 176

Pas de commentaire

Agilent Technologies 71501D Manuel d'utilisateur Page 19