Agilent Technologies E4438C Guide d'installation télécharger pdf (Page 94)

Adjustments

Overview of Adjustments

4-2

Overview of Adjustments

In this section you will learn about all available adjustments for the Agilent E4438C ESG vector signal

generator. These adjustments are performed so that the signal generator is properly calibrated.

CAUTION In all test equipment configurations, cables and adapters need to be properly torqued.

Exceeding recommended torque values may cause damage to a cable or adaptor and may cause

inaccurate test results.

Connector Type Torque Value

APC 3.5 Use an Agilent 8710-1765 at 8-lb inch when

connecting APC 3.5 (m) to APC 3.5 (f).

SMA Use an Agilent 8710-1765 at 8-lb inch when

connecting APC 3.5 (m) to SMA (f).

Use an Agilent 8710-1582 at 5-lb inch when

connecting SMA (m) to APC 3.5 (f).

Type-N Type-N connectors may be connected finger tight. If a

torque wrench is used, Agilent 8710-1766 at 12-lb.

inch is recommended.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 139 140

Pas de commentaire

Agilent Technologies E4438C Guide d'installation Page 94