Agilent-technologies Quaternary Pump 1100 Series Manuel d'utilisateur télécharger pdf (Page 218)

218

Introduction to the Quaternary Pump

Agilent 1100 Series Interfaces

The Agilent 1100 Series modules provide the following interfaces:

• The CAN connectors serve as the interface between the Agilent 1100

Series modules themselves,

• the GPIB connector serves as the interface between an Agilent1100

module and the Agilent ChemStation,

• RS-232C provides an interface to a computer,

• the APG remote connector serves as the interface between the

Agilent 1100 and other Agilent (APG remote compatible) products,

• the analog output connector(s) provide an analog signal output,

• the interface board slot (not common to all modules) provides specific

interfacing needs (external contacts, BCD, LAN and so on).

For identification and location of the connectors see Figure 3 on page 22.

Table 31 Agilent 1100 Series Interfaces

Interface Type Pumps Autosampler

DA Detector

MW Detector

FL Detector

VW Detector

RI Detector

Thermostatted

Column

Compartment

Vacuum

Degasser

CAN Yes Yes Yes Yes Yes No

GPIB Yes Yes Yes Yes Yes No

RS-232C Yes Yes Yes Yes Yes No

APG Remote Yes Yes Yes Yes Yes Yes

Analog Yes No 2 × 1 × No

Yes

Interface board Yes Yes Yes Yes No No

The vacuum degasser will have a special connector for specific use. For details, see the degasser manual.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 271 272

Pas de commentaire

Agilent-technologies Quaternary Pump 1100 Series Manuel d'utilisateur Page 218