Agilent Technologies N5416A Manuel de service Page 50

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 236
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 49
50 Notes on USB Electrical Compliance Testing
3 Device Hi-Speed Tests
Running the Tests
1 Click Run Tests.
Test Instructions
The USB automated test application will prompt you to perform these
steps:
1 On the HS Electrical Test Tool software, click [Enumerate Bus] once.
You should capture the CHIRP handshake as in the below figure.
2 Click OK to close the Test Instructions dialog.
EL_28 Measure Device CHIRP-K Latency
EL_29 Measure Device CHIRP-K Duration
EL_31 Hi-Speed Terminations Enable and D+ Disconnect Time
Viewing Test Results
1 When the Testing Complete dialog appears, click OK.
The Results tab shows the test results.
Vue de la page 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 235 236

Commentaires sur ces manuels

Pas de commentaire