Agilent Technologies Ininiium 9000 Spécifications télécharger pdf (Page 119)

Chapter 6: Replacing Assemblies

To remove and replace the front panel bezzle, front panel keyboard, touchscreen, and Autoprobe board

119

To remove and replace the front panel bezzle, front panel keyboard,

touchscreen, and Autoprobe board

1 Disconnect the power cable and remove the handle and rear cover as described above in the

section on removing the handle and rear cover.

2 Position the oscilloscope upright and disengage the series of tabs around the outside of the

front bezzle as shown in Figure 6-6.

3 With the tabs disengaged, pull the front bezzle off as shown in Figure 6-7.

Figure 6-6

Figure 6-7

Pull up on each of the front panel knobs to remove them from the front panel keyboard as

shown in Figure 6-8

Tabs on right side of

instrument

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 165 166

Pas de commentaire

Agilent Technologies Ininiium 9000 Spécifications Page 119