Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation télécharger pdf (Page 27)

Installing Logic Analyzer Cards and Probes 2

16900 Series Logic Analysis Systems Installation Guide 27

2 Remove filler panels as shown in the following figure.

a Loosen the thumb screws on the filler panels.

b Rotate the ejector levers from the locked position to the open

position.

c Remove filler panels.

3 If you are using a measurement module from a 16700 Series logic

analysis system go to “To replace thumb screws on measurement

modules” on page 24. If not, skip this step.

4 Ensure all ejectors are fully open and out of the way then slide the

module(s) into the logic analysis system frame.

The following figure shows a 6- card frame. The insertion/removal order

would be the same for a 3- card frame. A single- module configuration

can be installed in any available slot.

Locked position

Open position

Thumb screw

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 137 138

Pas de commentaire

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation Page 27