Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation télécharger pdf (Page 42)

42 16900 Series Logic Analysis Systems Installation Guide

2 Installing Logic Analyzer Cards and Probes

6 To verify the flex cables are installed correctly, use an ohm meter to

check continuity between the pair of test points associated with each

connector used.

If there is continuity (0 ohms), the flex cable is seated correctly in the

connector.

If there is no continuity (infinite ohms), the flex cable is not seated

correctly. Repeat the flex cable attachment steps, and check the

continuity again.

7 While maintaining alignment with the cards as a set, insert them the

rest of the way into the slots, seat them, lock the ejector tabs, and

tighten the thumb screws.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 137 138

Pas de commentaire

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation Page 42