Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation télécharger pdf (Page 107)

107

Chapter 6: Connecting Accessories

100-pin Differential Probe (E5379A for analyzers with 90-pin pod connectors)

100-pin Differential Probe (E5379A for analyzers with 90-pin pod

connectors)

NOTE: For use with Agilent logic analyzer modules 16760A, 16753A, 16754A,

16755A, and 16756A.

The Agilent E5379A is a 17-channel, 100-pin differential probe capable of

capturing data up to the rated maximum state (synchronous) analysis clock

rates of all the supported analyzers, with differential signal amplitudes as

small as 200 mV peak-to-peak (100 mV peak-to-peak on both positive and

negative inputs). Two E5379A probes are required to support all the inputs on

one 16760A. Four are required for one 16753/54/55/56A module. A 100-pin

connector must be installed on your target system board.

16-channel

Single-ended

100-pin Differential

Probe

Shroud

100-Pin

Connector

90-pin

Logic Analyzer

Pods

1.5pF

150ohm

Signal

Ground

20k

0.7pF

Equivalent Load

0.75V

Includes logic analyzer and 100-pin connector

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 149 150

Pas de commentaire

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation Page 107