Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation télécharger pdf (Page 42)

Chapter 2: Connecting and Configuring Hardware

To install, remove, or replace measurement modules

CAUTION: Electrostatic discharge can damage electronic components. Use grounded

wrist straps and mats when performing any service to measurement modules.

NOTE: Measurement modules with different model numbers may not be connected

together in multi-card (Master/Expander) modules unless stated otherwise.

For information on specific measurement modules go to:

1 Power down the system and disconnect the power cable before

installing, removing or replacing measurement modules.

2 Remove filler panels and carefully slide the module into the frame.

3 Gently apply pressure to the center of the module while tightening the

thumb screws.

Module Type Page

Logic Analyzer 45

Oscilloscope 71

Pattern Generator 87

Power

Busy

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 149 150

Pas de commentaire

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guide d'installation Page 42