Remote Interface Reference
• Command Summary, starting on page 105
• Simplified Programming Overview, starting on page 112
• The MEASure? and CONFigure Commands, starting on page 117
• Measurement Configuration Commands, starting on page 121
• Math Operation Commands, starting on page 124
• Triggering, starting on page 127
• Triggering Commands, starting on page 130
• System-Related Commands, starting on page 132
• The SCPI Status Model, starting on page 134
• Status Reporting Commands, starting on page 144
• Calibration Commands, on page 146
• RS-232 Interface Configuration, starting on page 148
• RS-232 Interface Commands, on page 153
• An Introduction to the SCPI Language, starting on page 154
• Output Data Formats, on page 159
• Using Device Clear to Halt Measurements, on page 160
• TALK ONLY for Printers, on page 160
• To Set the GPIB Address, on page 161
• To Select the Remote Interface, on page 162
• To Set the Baud Rate, on page 163
• To Set the Parity, on page 164
• To Select the Programming Language, on page 165
• Alternate Programming Language Compatibility, starting on page 166
• SCPI Compliance Information, on page 168
• IEEE-488 Compliance Information, on page 169
If you are a first-time user of the SCPI language, you may want to refer to these sections
to become familiar with the language before attempting to program the multimeter.
>
>
104
Commentaires sur ces manuels