Agilent Technologies C-Size VXIbus Systems Manuel d'utilisateur télécharger pdf (Page 41)

Series 700-2 : Set Up the Agilent E1406A Command Module

If an Agilent E1406A Command Module is part of your Series 700/MXI

based VXIbus system, you must configure the Command Module for use

with the Series 700 computer and the Agilent E1482B VXIbus Extender

module. This includes:

• setting the Command Module logical address so that it is a servant to

the Series 700

• setting the Command Module servant area so that it is the

commander of the system’s Agilent Technologies register-based

modules

• setting the Command Module primary GPIB address

• disabling the Command Module’s slot 0 and system controller

capability

• disabling the Command Module’s VMEbus Time Out capability

In VXIbus systems with an HP Series 700 computer, Agilent E1482B

MXIbus Extender, and a Agilent E1406A Command Module, the

following configuration is recommended:

– Series 700 (with the Agilent E1489I MXIbus Controller

Interface) is the resource manager

– Agilent E1482B MXIbus Extender is the slot 0 device

– Agilent E1406A Command Module is the commander to the

system’s Agilent Technologies register-based modules

The resource manager and slot 0 functions and commander/servant

hierarchy concepts are covered in Appendix A "Terms and Definitions".

C-Size Configuration Guide Setting Up a Series 700 Computer 2-23

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 177 178

Pas de commentaire

Agilent Technologies C-Size VXIbus Systems Manuel d'utilisateur Page 41