Agilent Technologies C-Size VXIbus Systems Manuel d'utilisateur télécharger pdf (Page 44)

Series 700 computer’s (GPIB) interface select code (typically 7), to form

the Command Module’s complete GPIB address.

Series 700-2D :

Disabling the

Command Module’s

Slot 0 Capability

Because the Agilent E1482B VXIbus Extender module is the system’s slot

0 module, the slot 0 and VME system controller capability of the Command

Module must be disabled. This is done by setting the "System Controller"

and "Slot 0" switches to the "Disable" position. The location of these

switches is shown in Figure 2-18.

Series 700-2E :

Disabling the

Command Module’s

VMEbus Time Out

Capability

When E1482 VXIbus Extender modules are part of your system, the

modules must function as the Data Transfer Bus (DTB) timer. This means

the bus timer capability of the Command Module must be disabled. This is

done by setting the ’VME BTO Disable’ switch as indicated in Figure 2-19.

The VMEbus timer capability (VME BTO Level) of the E1482B is enabled

at the factory.

Figure 2-18. Disabling the E1406A Slot 0 Capability

2-26 Setting Up a Series 700 Computer C-Size Configuration Guide

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 177 178

Pas de commentaire

Agilent Technologies C-Size VXIbus Systems Manuel d'utilisateur Page 44