Agilent Technologies AGILENT U2761A Manuel de service télécharger pdf (Page 110)

9 Triggering Commands

102 U2761A Programmer’s Reference

OUTPut:TRIGger[:STATe]

Syntax

OUTPut:TRIGger[:STATe] {0|OFF|1|ON}

This command disables or enables the “trigger out” signal on the Trig Out

connector. When enabled, a TTL- compatible Square waveform with the

specified edge is output from the Trig Out connector at the beginning of

the sweep.

OUTPut:TRIGger[:STATe]?

This query returns the trigger output state as 0 if the “trigger out” signal

is disabled, or 1 if the signal is enabled.

Parameter

Examples

The following command enables the trigger output.

OUTP:TRIG ON

The following query returns the trigger output state.

OUTP:TRIG?

Typical response:

Item Type Range of values Default value

state Boolean 0|OFF|1|ON 0

OUTP :TRIG space

0|OFF

1|ON

:STAT

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 168 169

Pas de commentaire

Agilent Technologies AGILENT U2761A Manuel de service Page 110