Agilent-technologies 34401A Manuel d'utilisateur télécharger pdf (Page 152)

Calibration Commands

See “Calibration Overview” starting on page 95 for an overview of the

calibration features of the multimeter. For a more detailed discussion

of the calibration procedures, see chapter 4 in the Service Guide.

CALibration?

Perform a calibration using the specified calibration value

(CALibration:VALue command). Before you can calibrate the

multimeter, you must unsecure it by entering the correct security code.

CALibration:COUNt?

Query the multimeter to determine the number of times it has been

calibrated. Your multimeter was calibrated before it left the factory.

When you receive your multimeter, read the count to determine its

initial value. [Stored in non-volatile memory]

• The calibration count increments up to a maximum of 32,767 after

which it wraps-around to 0. Since the value increments by one for

each calibration point, a complete calibration will increase the value

by many counts.

CALibration:SECure:CODE <

new code>

Enter a new security code. To change the security code, you must first

unsecure the multimeter using the old security code, and then enter a

new code. The calibration code may contain up to 12 characters.

[Stored in non-volatile memory]

CALibration:SECure:STATe {OFF|ON},<

code>

Unsecure or secure the multimeter for calibration. The calibration code

may contain up to 12 characters. [Stored in non-volatile memory]

CALibration:SECure:STATe?

Query the secured state of the multimeter. Returns “0” (

OFF) or “1” (ON).

Chapter 4 Remote Interface Reference

Calibration Commands

146

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 241 242

Pas de commentaire

Agilent-technologies 34401A Manuel d'utilisateur Page 152