Agilent Technologies Sprinkler 54753a Manuel d'utilisateur télécharger pdf (Page 24)

Command

:MARKer:X1Y1source[?] {CHANnel<number> |

FUNCtion<number> | RESPonse<number> |

WMEMory<number> | HISTogram | FFT}

Sets the source for the X1 and Y1 markers.

For channels: an integer, 1 through 4, indicating the slot in which the channel

resides, followed by an optional A or B indicating which of two possible

channels in the slot is being referenced. For functions: 1 or 2. For waveform

memories (WMEMory): 1, 2, 3, or 4. For TDR response: 1, 2, 3, or 4.

Command

:MARKer:X2Y2source[?] {CHANnel<number> |

FUNCtion<number> | RESPonse<number> |

WMEMory<number> | HISTogram | FFT}

Sets the source for the X2 and Y2 markers.

For channels: an integer, 1 through 4, indicating the slot in which the channel

resides, followed by an optional A or B indicating which of two possible

channels in the slot is being referenced. For functions: 1 or 2. For waveform

memories (WMEMory): 1, 2, 3, or 4. For TDR response: 1, 2, 3, or 4.

Command

:MARKer:XUNITs[?] {SECond | METer | FEET}

Sets the units for horizontal display in TDR and TDT applications. The units

may be in seconds, meters, or feet relative to the trigger or reference plane.

The marker mode must be TDRTDT to use this feature. See the

:MARKer:REFerence command for information on setting the reference point.

Command

:MARKer:YUNITs[?] {VOLT | OHM | REFlect}

Sets the units for vertical display in TDR and TDT applications. The units

may be in volts, ohms, or % relection. The marker mode must be TDRTDT to

use this features.

Marker Commands

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Pas de commentaire

Agilent Technologies Sprinkler 54753a Manuel d'utilisateur Page 24