Agilent Technologies J3916A Manuel d'utilisateur télécharger pdf (Page 60)

Exiting the Main Menu and Restarting the Probe

1. On the Main menu, Press

to execute a warm start or press

to execute a

cold start.

A cold start is required if you change the IP Address, Default Gateway, or

Subnet Mask. For either menu choice, the probe exits the Main Menu and

restarts normal operations.

2. If you are performing the initial probe configuration, prepare the probe for

installation by disconnecting the power cord. You will not lose your initial

configuration information.

NOTE

A warm start resets all data collected by the probe. A cold start resets all data

collected by the probe and also resets any user-configuration information, such as

history studies, filters, and alarms to their default values. Refer to “Probe

Operation” on page 89 for more information on what is reset by warm and cold

starts.

After the probe restarts (boots), it operates normally using the new configuration

information. The warm start or cold start occurs immediately and there is no

visual indication of when it finishes.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 178 179

Pas de commentaire

Agilent Technologies J3916A Manuel d'utilisateur Page 60