Agilent Technologies E1345A Manuel d'utilisateur télécharger pdf (Page 54)

Relay Multiplexer Command Reference 55

INITiate

The INITiate subsystem selects continuous scanning cycles and starts the scanning

cycle.

Subsystem Syntax INITiate

:CONTinuous <

mode>

:CONTinuous?

[:IMMediate]

:CONTinuous

INITiate:CONTinuous <mode> enables or disables continuous scanning cycles for

the switchbox.

Parameters

Comments • Continuous Scanning Operation: Continuous scanning is enabled with the

INITiate:CONTinuous ON or INITiate:CONTinuous 1 command. Sending the

INITiate[:IMMediate] command closes the first channel in the channel list. Each

trigger from a trigger source selected by the

TRIGger:SOURce command

advances the scan through the channel list. A trigger at the end of the channel

list closes the first channel in the list and the scan cycle repeats.

• Non-Continuous Scanning Operation: Non-Continuous scanning is enabled

with the

INITiate:CONTinuous OFF or INITiate:CONTinuous 0 command.

Sending the

INITiate[:IMMediate] command closes the first channel in the

channel list. Each trigger from a trigger source selected by the

TRIGger:SOURce command advances the scan through the channel list. A

trigger at the end of the channel list opens the last channel in the list and the

scanning cycle stops.

• Stopping Continuous Scans: See the ABORt command.

• Related Commands: ABORt, ARM:COUNt, TRIGger, TRIGger:SOURce

• *RST Condition: INITiate:CONTinuous OFF

Example Enabling Continuous Scans

INIT:CONT ON

Enables continuous scanning.

SCAN (@100:115)

Sets channel list.

INIT

Starts scanning cycle.

Parameter Name Parameter Type Range of Values

mode>

boolean 0|1|ON|OFF

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 92 93

Pas de commentaire

Agilent Technologies E1345A Manuel d'utilisateur Page 54