Agilent Technologies E6640A EXM Manuel de service télécharger pdf (Page 10)

10 Getting Started Guide

1 Quick-Start

About the Test Set

The E6640A EXM Wireless Test set contains one to four Agilent M9430A TRXs. Each

TRX contains the full set of hardware elements illustrated below, and is run by its own

instance of the XSA firmware application (a fully loaded test set shows four independent

XSA windows on its monitor display).

The TRX includes a signal analyzer and a signal source, both of which interface with the

front panel of the test set through an input/output matrix, and each of which is controlled

by an independent list sequencer (the two sequencers exchange trigger signals to

coordinate their operations). The input/output matrix is illustrated below. Ports RFIO 1

and RFIO2 are full-duplex ports (simultaneously inputs and outputs). Ports RF3 I|O and

RF4 I|O can be inputs or outputs, but not simultaneously. See also: “TRX Selection" on

page 18,“Port Configuration" on page 24.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 117 118

Pas de commentaire

Agilent Technologies E6640A EXM Manuel de service Page 10