Agilent Technologies HP8648A Manuel d'utilisateur télécharger pdf (Page 104)

100

101

FM Receivers

103

Once the Sending:

13 Press the PREV key to return to the RX TEST screen.

14 Set RF Gen Freq to the receiver operating frequency.

15 Set Amplitude to −47 dBm (1 mV).

16 Set AFGen1 To 60% of the Receiver’s specified maximum frequency de-

viation (typically 3 kHz).

17 Set Ext Load R to the test load resistance.

18 Set AC Level meter to measure Watts.

On the Radio set the Receiver’s Controls as follows:

19 Set power to ON.

20 If required, set frequency to the same value as step 4j.

21 Set RF Gain to maximum (if equipped).

22 Set squelch control to minimum (if equipped).

23 Set the volume control until the AC Level reads 100% of the Receiver’s

specified audio output.

Refer to the audio output specifications for the receiver being tested.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 319 320

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies HP8648A Manuel d'utilisateur Page 104

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies HP8648A