Agilent Technologies HP8648A Manuel d'utilisateur Page 247

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 320
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 246
Preparing the Test Set for DC Operation
246
Preparing the Test Set for Operation
1. Verify that the instrument is connected and configured to the appropriate
power source.
NOTE: Because most parameters are saved when power is removed, setting
configuration is NOT necessary every time power is applied to the Test Set.
Perform these procedures only if changes to the fields are required.
2. Turn the Test Set POWER ON (in). After approximately 15 seconds, verify
that the CRT screen displaysAll self tests passed” and that the “RX
TEST” screen is displayed.
3. Press the CONFIG key to display the CONFIGURE screen.
cnfgscrn.wmf
Vue de la page 246
1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 319 320

Commentaires sur ces manuels

Pas de commentaire