Agilent Technologies InfiniiVision 3000 X-Series Manuel d'utilisateur télécharger pdf (Page 23)

Acquisition modes

All 3000 X-Series models

Characteristics

Normal

Peak detect Capture glitches as narrow as 250-ps at all timebase settings

Averaging Selectable from 2, 4, 8, 16, 64, ... to 65,536

High Resolution Mode 12 bits of resolution when ≥10 µs/div at 4 GSa/s or ≥20-µs/div at 2 GSa/s

Segmented (optional) Re-arm time = 1 µs (minimum time between trigger events)

Waveform measurements

All 3000 X-Series models

Characteristics

Cursors** • Single cursor accuracy:

±[DC vertical gain accuracy + DC vertical offset accuracy + 0.25% full scale]

• Dual cursor accuracy:

±[DC vertical gain accuracy + 0.5% full scale]*

• Units: Seconds(s), Hz (1/s), Phase (degrees), Ratio (%)

Automatic measurements Measurements continuously updated with statistics. Cursors track last selected

measurement. Select up to four measurements from the list below:

• Voltage: peak-to-peak, maximum, minimum, amplitude, top, base, overshoot, pre-shoot,

average- N cycles, average- full screen, DC RMS- N cycles, DC RMS- full screen, AC RMS- N

cycles, AC RMS- full screen (standard deviation), ratio (RMS1/RMS2)

• Time: period, frequency, counter, + width, - width, burst width, duty cycle, rise time, fall time,

delay, phase, X at min Y, X at Max Y

• Count: positive pulse count, negative pulse count, rising edge count, falling edge count

• Mixed: area- N cycles, area- full screen

Counter Built-in frequency counter:

• Source: on any analog or digital channel

• Resolution: 5 digits

• Maximum frequency: bandwidth of scope

Waveform math

All 3000 X-Series models

Characteristics

Arithmetic f (g(t))

g(t): { add, subtract, multiply between any 2 channels}

f(t): {FFT(g(t)), differentiate d/dt g(t), integrate ∫ g(t) dt, square root √g(t) }

Enabled between any combination of two channels

Arithmetic DSOX3ADVMath advanced waveform math option adds Ax + B, Square, Absolute,

Common Log, Natural Log, Exponential, Base 10 Exponential, LP Filter, HP Filter, Magnify,

Measurement Trend, Chart Logic Bus (Timing or State).

FFT Up to 64 kpts resolution

Set FFT Window to: Hanning, Flat Top, Rectangular, Blackman-Harris

Oscilloscopes redefined: Breakthrough technology delivers more scope for the same budget

Performance characteristics

* Denotes warranted specifications, all others are typical.

Specifications are valid after a 30-minute warm-up period and ±10 °C from firmware calibration temperature.

** 1 mV/div and 2 mV/div is a magnification of 4 mV/div setting. For vertical accuracy calculations, use full scale of 32 mV for 1 mV/div and 2 mV/div

sensitivity setting.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies InfiniiVision 3000 X-Series Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies InfiniiVision 3000 X-Series