Agilent Technologies Agilent B2201A Manuel d'utilisateur télécharger pdf (Page 159)

Agilent B2200 User’s Guide, Edition 2 5-33

SCPI Command Reference

[:ROUTe]:BIAS[:STATe]

In this example, A will be 4.

[:ROUTe]:BIAS[:STATe]

NOTE You cannot set the Bias Mode to ON when the Ground Mode is ON.

This command controls the Bias Mode for the specified card. When the Bias Mode

is ON, the input Bias Port is connected to the all bias-enabled output ports that have

not been connected to any other input port. At *RST, the Bias Mode is OFF.

The query returns the mode status of the specified card.

The input Bias Port is set by “[:ROUTe]:BIAS:PORT”. The bias-enabled output

ports (channels) are set by “[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]” or

“[:ROUTe]:BIAS:CHANnel:ENABle:CARD”.

When the Bias Mode is ON, you cannot directly control the Bias Port connections.

However, they can be indirectly controlled when the connections of the other input

port are controlled.

When the Bias Mode is OFF, the input Bias Port is the same as the other input ports,

so relays can be controlled directly to connect to output ports.

Syntax [:ROUTe]:BIAS[:STATe] card_number,state

[:ROUTe]:BIAS[:STATe]? card_number

Query response 0 or 1 <newline><^END>

0: OFF

1: ON

Example OUTPUT @Agb2200;":ROUT:BIAS:STAT ALL,ON"

OUTPUT @Agb2200;":ROUT:BIAS:STAT? 4"

ENTER @Agb2200;A

In this example, A will be 1.

Parameter Explanation

card_number For Auto Config mode: 0 or ALL

For Normal Config mode: 1, 2, 3, 4, or ALL

ALL is not available for query.

state ON or 1: sets the Bias Mode ON

OFF or 0: sets the Bias Mode OFF

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 233 234

Pas de commentaire

Agilent Technologies Agilent B2201A Manuel d'utilisateur Page 159