Agilent Technologies Switch E2050-90003 Manuel d'utilisateur télécharger pdf (Page 31)

Chapter 2 31

Installation

Installing the Hardware

Step 5: Observe the Power-On Sequence

n The Gateway now goes through its power-on, hardware self-test.

Verify that the hardware is working properly by looking at the LEDs

on the front panel of the Gateway.

n The green Power LED should now be illuminated and the red Fault

LED should be off. One or more of the yellow LAN LEDs may also

be flashing. Ignore the LAN LEDs at this time.

n The red Fault LED is illuminated briefly at power-on to verify its

operation. If the

Fault LED remains illuminated, a hardware fault was

found during the power-on, hardware self-test of the Gateway.

Please contact Agilent Technologies for instructions. Service is

required only if the

Fault LED remains illuminated.

n Once you have verified that the hardware is working properly (the

Gateway’s green

Power LED is illuminated), disconnect the

standard AC power cord from the power outlet (wall outlet).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 109 110

Pas de commentaire

Agilent Technologies Switch E2050-90003 Manuel d'utilisateur Page 31