Agilent Technologies Switch E2050-90003 Manuel d'utilisateur télécharger pdf (Page 93)

Chapter 5 93

Troubleshooting

Troubleshooting Gateway Configuration

4 Verify the BOOTP server is on the same local subnet as the

Gateway. If not, consult your Network Administrator to verify that

your network configuration supports using a BOOTP server that is

not on the same subnet.

5 When the Gateway is powered on, verify there is a fast flash on the

LAN Conn LED.

Troubleshooting BOOTP with TFTP Configuration

If you have trouble configuring the LAN/GPIB Gateway using the BOOTP

with TFTP configuration method:

1 Follow the steps in “Troubleshooting BOOTP Configuration”.

2 Verify that the TFTP server system is configured to run the tftpd

daemon. See the Administering ARPA Services manual for more

information.

3 Consult your BOOTP server documentation to verify you have the

correct permissions on the specified TFTP configuration file.

4 Verify that the Gateway’s configuration values are correct in the

TFTP file.

5 Look for errors specific to the TFTP values in the syslog file on the

configured syslog server or with the Telnet syslog-display

command.

NOTE

Your BOOTP server may support the bootpquery capability to verify

your BOOTP configuration. See your BOOTP server documentation for

how to use the bootpquery command.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 109 110

Pas de commentaire

Agilent Technologies Switch E2050-90003 Manuel d'utilisateur Page 93