Agilent Technologies Switch E2050-90003 Manuel d'utilisateur télécharger pdf (Page 47)

Chapter 3 47

Configuration

Configuration Methods

10 At the Telnet prompt (>), enter the configuration values you want to

change or set. (You only need to specify the non-default values that

you want.) The following information will help you set the values

correctly.

The following table lists the configuration values you can set using

Telnet. The following information shows the syntax you should use

and provides tips to help you to change or set the configuration

values correctly.

NOTE

By using the Telnet configuration method, the LAN hardware address

(hardware-addr:) value is automatically set to the correct hardware

address for this LAN/GPIB Gateway. Do not change the hardware

address value via Telnet. Its value in the Telnet configuration table is for

information purposes only.

Configuration Value Telnet Command Default Value

Hostname hostname: E2050

IP Address ip: 192.0.0.192

Default Subnet Gateway Address gateway: 0.0.0.0

Subnet Mask subnet-mask: 0.0.0.0

Syslog Server Address syslog-svr: 0.0.0.0

BOOTP bootp: ON

LAN Timeout lan-timeout: 0

I/O Timeout io-timeout: 120

IP Allow List allow: * (All allowed)

GPIB Address hpib-address: 21

GPIB Interface Name hpib-name:

hpib

GPIB Logical Unit hpib-unit: 7

Change name to gpib0 for VXI-11 compatibility

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 109 110

Pas de commentaire

Agilent Technologies Switch E2050-90003 Manuel d'utilisateur Page 47