Agilent Technologies All Guide de dépannage télécharger pdf (Page 146)

Lab Exercise: Customized Report Design

Inserting Tables

138

Inserting Tables

1) Below the chromatogram, expand the size of the general white space.

2) Select the Table Tool,

and outline a space approximately 80 x 20.

3) Select Cal. Peaks Sorted by Ret. Time. The Setup Cal. Peaks sorted by Ret.

Time table should appear. From the Printed Columns box select Response

Factor then <. Note that you have removed this item from the Printed

Columns list. Check that the table layout lies within the bounding box length.

Remove Expected Retention Time, as well. OK the table and adjust the size

of the box, if necessary.

Creating a Table Footer

1) Double click on the table box. Click on the Edit Format button in the Set-up.

2) When the Edit Format of Cal. Peaks panel is displayed click on Footer.

3) Click on the button labeled 2 Lines. In the Amount row, Line 2 column,

type: @sum. In the first row (#), Line 2 column, type: Total. OK this panel.

In the Edit Format panel, change the width of the # row to 6. OK this panel

and the subsequent panel.

Inserting a Page break

1) Click on the Page Break Tool,

then click in the white space below the table to insert a page break.

2) Reposition the bottom General Section border by dragging the border up to

the page break (the blue band).

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 210 211

Pas de commentaire

Agilent Technologies All Guide de dépannage Page 146