Agilent Technologies 86100A Manuel de service télécharger pdf (Page 17)

100

101

1-13

Introduction

Status Reporting

The use of bit 6 can be confusing. This bit was defined to cover all possible computer inter-

faces, including a computer that could not do a serial poll. The important point to remember

is that, if you are using an SRQ interrupt to an external computer, the serial poll command

clears bit 6. Clearing bit 6 allows the instrument to generate another SRQ interrupt when

another enabled event occurs. The only other bit in the Status Byte Register affected by the

*STB? query is the Message Available bit (bit 4). If there are no other messages in the Output

Queue, bit 4 (MAV) can be cleared as a result of reading the response to the *STB? query.

If bit 4 (weight = 16) and bit 5 (weight = 32) are set, a program would print the sum of the

two weights. Since these bits were not enabled to generate an SRQ, bit 6 (weight = 64) is not

set.

Figure 1-3. Status Reporting Overview

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 363 364

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies 86100A Manuel de service Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies 86100A