Agilent Technologies 86100A Manuel de service télécharger pdf (Page 205)

12-5

Function Commands

HORizontal:RANGe

40 ENTER 707;Value

HORizontal:RANGe

Command :FUNCtion<N>:HORizontal:RANGe <range_value>

This command sets the current time range for the specified function. This automatically

selects manual mode. <range_value> is the width of screen in current X-axis units (usually

seconds).

Restrictions This command applies only to the Magnify and Versus operators. If this function is used on

operators other than Magnify or Versus, no error message is returned regardless of software

revision.

Query :FUNCtion<N>:HORizontal:RANGe?

The query returns the current time range setting of the specified function.

NOTE This query returns the current time range setting of the specified function only when the respective function

display is ON.

Returned Format [:FUNCtion<N>:HORizontal:RANGe] <range><NL>

Example 20 OUTPUT 707;":FUNCTION2:DISPLAY ON"

30 OUTPUT 707;":FUNCTION2:HORIZONTAL:RANGE?"

INVert

Command :FUNCtion<N>:INVert <operand>

This command defines a function that inverts the defined operand's waveform by multiplying

by –1.

Restrictions Not available in Jitter mode.

<operand> {CHANnel<N> | FUNCtion<N> | RESPonse<N> | WMEMory<N> | <float_value>}

Example This example sets up function 2 to invert the signal on channel 1.

10 OUTPUT 707;":FUNCTION2:INVERT CHANNEL1"

MAGNify

Command :FUNCtion<N>:MAGNify <operand>

This command defines a function that is a copy of the operand. The magnify function is a

software magnify. No hardware settings are altered as a result of using this function. It is use-

ful for scaling channels, another function, TDR/TDT responses or memories with the RANGe

and OFFSet commands in this subsystem.

<operand> {CHANnel<N> | FUNCtion<N> | RESPonse<N> | WMEMory<N> | <float_value>}

Example 10 OUTPUT 707;":FUNCTION1:MAGNIFY CHANNEL1"

MAXimum

Command :FUNCtion<N>:MAXimum <operand>

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 363 364

Pas de commentaire

Agilent Technologies 86100A Manuel de service Page 205