Agilent Technologies 86100A Manuel de service télécharger pdf (Page 266)

18-16

Measure Commands

HISTogram:HITS?

<value> is the frequency value, in Hertz, of the first complete cycle on the screen using the

mid-threshold levels of the waveform. If SENDvalid is ON, the <result_state> is returned with

the measurement result. Refer to Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:MEASURE:FREQUENCY”

HISTogram:HITS?

Query :MEASure:HISTogram:HITS? [{HISTogram}]

Returns the number of hits within the histogram. The source can be specified with the

optional parameter following the HITS query. The HISTogram:HITS? query only applies to the

histogram.

Returned Format [:MEASure:HISTogram:HITS] <value>[,<result_state>]<NL>

<value> is the number of hits in the histogram. If SENDvalid is ON, the <result_state> is

returned with the measurement result. Refer to Table 18-3 on page 18-30 for a list of the

result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:HISTOGRAM:HITS?”

HISTogram:M1S?

Query :MEASure:HISTogram:M1S? [{HISTogram}]

Returns the percentage of points that are within one standard deviation of the mean of the

histogram. The source can be specified with the optional parameter following the M1S query.

The HISTogram:M1S? query only applies to the histogram waveform.

Returned Format [:MEASure:HISTogram:M1S] <value>[,<result_state>]<NL>

<value> is the percentage of points within one standard deviation of the mean of the histo-

gram. If SENDvalid is ON, the <result_state> is returned with the measurement result. Refer

to Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:HISTOGRAM:M1S?”

HISTogram:M2S?

Query :MEASure:HISTogram:M2S? [{HISTogram}]

Returns the percentage of points that are within two standard deviations of the mean of the

histogram. The sources can be specified with the optional parameter following the M2S

query. The HISTogram:M2S? query only applies to the histogram waveform.

Returned Format [:MEASure:HISTogram:M2S] <value>[,<result_state>]<NL>

<value> is the percent of points within two standard deviations of the mean of the histogram.

If SENDvalid is ON, the <result_state> is returned with the measurement result. Refer to

Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:HISTOGRAM:M2S?”

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 363 364

Pas de commentaire

Agilent Technologies 86100A Manuel de service Page 266