Agilent Technologies 86100A Manuel de service télécharger pdf (Page 256)

18-6

Measure Commands

CGRade:CROSsing

Returned Format [:MEASure:CGRade:CRATio] <value>[,<result_state>]<NL>

<value> is the contrast ratio. If SENDvalid is ON, the <result_state> is returned with the

measurement result. Refer to Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:CGRADE:CRATIO? PERCENT”

CGRade:CROSsing

Command :MEASure:CGRade:CROSsing [{CHANnel<N> | FUNCtion<N> | CGMemory}]

Measures the crossing level percent of the current eye diagram on the color grade or gray

scale display. The data for color grade display is the same as for gray scale display. If the

source is not set, the lowest numbered signal that is on will be the source of the measure-

ment.

Mode Eye mode only. Ensure that the eye type is set to NRZ. See “DEFine” on page 18-11.

Query :MEASure:CGRade:CROSsing? [{CHANnel<N> | FUNCtion<N> | CGMemory}]

The query returns the crossing level percent of the current eye diagram on the color grade or

gray scale display.

Returned Format [:MEASure:CGRade:CROSsing] <value>[,<result_state>]<NL>

<value> is the crossing level. If SENDvalid is ON, the <result_state> is returned with the

measurement result. Refer to Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:CGRade:CROSsing?”

CGRade:DCDistortion

Command :MEASure:CGRade:DCDistortion <format>[,{CHANnel<N> | FUNCtion<N> | CGMemory}]

Measures the duty cycle distortion on the eye diagram of the current color grade or gray scale

display. The parameter specifies the format for reporting the measurement. The data for

color grade display is the same as for gray scale display. If the source is not set, the lowest

numbered signal that is on will be the source of the measurement. <format> is {TIME | PER-

Cent}.

Mode Eye mode only. Ensure that the eye type is set to NRZ. See “DEFine” on page 18-11.

Query :MEASure:CGRade:DCDistortion? <format> [,{CHANnel<N> | FUNCtion<N> | CGMemory}]

The query returns the duty cycle distortion of the color grade or gray scale display.

Returned Format [:MEASure:CGRade:DCDistortion] <value>[,<result_state>] <NL>

<value> is the duty cycle distortion. If SENDvalid is ON, the <result_state> is returned with

the measurement result. Refer to Table 18-3 on page 18-30 for a list of the result states.

Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”

20 OUTPUT 707;”:MEASURE:CGRADE:DCDistortion? PERCENT”

CGRade:DCYCle

Command :MEASure:CGRade:DCYCle [<source>]

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 363 364

Pas de commentaire

Agilent Technologies 86100A Manuel de service Page 256