Agilent Technologies HP 54601B Guide de l'utilisateur télécharger pdf (Page 37)

To assign a testing mask to a step

Before using a testing mask in a test step, the mask must be created and

stored in one of the forty mask memories.

1 Press Print/Utility twice.

2 Press the Sequence Admin softkey.

3 Press the Define Sequence softkey.

4 Press the Step softkey, or turn the knob closest to the Cursors key,

to select the step number for the testing mask number.

5 Press the Use Mask softkey.

6 Press the Use Mask softkey, or turn the knob closest to the Cursors

key, to select the mask number for testing.

Selecting the mask immediately assigns it to the selected step.

Mask Template Testing operating hint

When a mask template is used in a step, it compares the signal of the lowest

number of all active channels against the mask template. For example, if

channels 1, 3, and 4 are active, channel 1 is compared against the mask

template; if channels 2, 3, and 4 are active, channel 2 is compared against the

mask template.

Mask template testing cannot be used in conjunction with the delay sweep, roll

mode, or math functions.

To use mask template testing in the XY mode, refer to the section "To use mask

template testing in the XY mode" in this chapter.

Operating the Test Automation Module

To assign a testing mask to a step

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 122 123

Pas de commentaire

Agilent Technologies HP 54601B Guide de l'utilisateur Page 37