Agilent Technologies HP 54601B Guide de l'utilisateur télécharger pdf (Page 51)

Permit operating hint

Different levels of permit can be set for different steps of a sequence. To allow

the operator to make fine adjustments to fit the signal into the mask, specify the

permit to be Adjust. Only knobs in the vertical and horizontal system can be

accessed by the operator. The vernier mode of either the vertical or horizontal

system may be turned on prior to saving the setup. Then, the operator can

have fine adjustment on either the vertical or horizontal directions to fit the

signal into the mask.

If the operator accesses keys or knobs that are disabled, the warning message

"Access not permitted" is displayed.

Operating the Test Automation Module

To prevent the operator from changing the setup

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 122 123

Pas de commentaire

Agilent Technologies HP 54601B Guide de l'utilisateur Page 51