Agilent Technologies HP 54601B Guide de l'utilisateur télécharger pdf (Page 68)

Creating an overshoot testing mask

There are two parameters associated with the overshoot of a signal: the

percentage of overshoot and the settling time of the overshoot. A mask

template can be created to test the upper limit of these two parameters at

the same time. Figure 14 shows an example of a mask template for testing

overshoot.

Example of a mask template for testing overshoot

The critical factors for creating the mask template are:

•

To optimize testing speed, the information on the signal before the rising

edge should not be tested since it is not required for overshoot testing.

•

The vertical window of the middle region of the mask template determines

the upper limit of the overshoot.

•

The horizontal window of the middle region determines the upper limit of

the settling time.

•

The vertical window of the rightmost region determines the settling

window. Normally, the settling window is ±5% or ±10% of the

V top voltage.

Figure 14

Solutions

Creating an overshoot testing mask

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 122 123

Pas de commentaire

Agilent Technologies HP 54601B Guide de l'utilisateur Page 68