Agilent Technologies All Guide de dépannage télécharger pdf (Page 110)

Lab Exercise: Running a Sequence

Building a Sequence

102

7) Now enter the Sequence Table from the Sequence menu or from the

sequence tray setup tool. You would like to do the following:

a) Replace all existing calibration table response factors with new response

factors at all three calibration standard levels.

b) There after, perform cyclic recalibrations every 2 sample injections

averaging the response factors and retention times.

c) Perform four sample injections, in this case utilize the vial containing your

isocratic test mix and make four injections from this vial.

Fill in the table. Each time you wish to add a new line to the bottom of the table,

highlight the last line by clicking on the line number, then use the Append Line

button. To add a line above the currently highlighted line, use the Insert button.

The table should look like the one below. You can also try to use the

Insert/FillDown Wizard.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 210 211

Pas de commentaire

Agilent Technologies All Guide de dépannage Page 110